磷石膏提质降杂实验研究

磷石膏的综合利用对保护环境、促进企业可持续健康发展具有重要意义,但是磷石膏中的磷、氟、二氧化硅等杂质影响其利用。针对云南磷石膏中二氧化硅含量高的问题,采用正浮选工艺开展了磷石膏提质降杂的实验研究。通过单因素条件实验获得了合适的工艺参数：浮选温度为15 ℃、矿浆pH为2、十二胺用量为300 g/t。在此条件下,进行了“一粗二精”的正浮选开路流程实验,获得了二水石膏（CaSO₄·2H₂O）质量分数为97.5%、二氧化硅质量分数为1.17%的精矿,所得精矿达到了GB/T 23456—2018《磷石膏》一级品指标的要求;二水石膏回收率为98.58%、二氧化硅去除率为92.23%。通过正浮选不仅成功实现了二水石膏和二氧化硅的有效分离,而且磷石膏中的水溶磷和水溶氟也得到了有效去除,从而提高了磷石膏的品质。     

电弧炉炼钢碳化硅白渣工艺的脱氧与脱硫

理论计算和实践表明，在电弧炉上采用碳化硅代替硅铁粉和碳粉的白渣还原工艺，可强化钢的脱氧和脱硫效果；提高电炉炼钢生产效率；降低吨钢电耗和生产成本。并指出，采用喷吹技术会进一步改善该工艺的炼钢技术经济效果。     

中频炉酸性炉衬使用寿命的探讨

通过对炉衬材料的选择,作用机理及影响石英砂炉衬材料寿命的相关因素的阐述,说明了SD-T-A石英砂干振料可提高中频炉酸性炉衬使用寿命的原因.     

2—甲基—1，4—萘醌对DNA光敏损伤的诱导作用

选择波长337nm的激光作为激励光源，借助凝胶电泳研究了2－甲基－1，4－萘醌诱导的DNA光敏损伤。结果表明：在氧气饱和、脱氧条件下光敏损伤显著，DNA损伤主要与光子剂量、核酸与萘醌浓度比及DNA存在形式有关。     

Ionic liquid mediated nano-composite polymer gel electrolyte for rechargeable battery application

ABSTRACT

Nano-composite polymer gel electrolytes (NPGEs) based on polymer poly(vinylidene fluoride-co-hexafluoropropylene) PVdF-HFP, ionic liquid, 1-butyl-3- methylimidazolium bis(trifluoromethanesulfonyl)imide BMIMTFSI, Li-salt along with the addition of SiO₂ nanoparticles have been synthesized and characterized by various techniques. Prepared NPGEs show high room temperature ionic conductivity (~10^?3 S/cm) and have a wide electrochemical window (ECW) (~3.3–3.5 V). The galvanostatic charge/discharge profile was studied by sandwiching best performing NPGEs between a LiFePO₄ cathode and lithium metal anode. The specific discharge capacity of the cell (Li/NPGE/LiFePO₄) room temperature at 0.1C rate is found to be 138 mAh/g.     

NO reduction by CH4 over Pd/Co-sulfated zirconia catalysts

A series of sulfated zirconia supported Pd/Co catalysts was synthesized by the sol–gel method and examined for NO_x reduction by methane. The NO conversion increased up to a Co/S ratio of 0.43, and then decreased at a higher Co loading (Co/S = 0.95). Sulfate content was also essential for obtaining high selectivity to molecular nitrogen. A catalyst loaded with 0.06 wt.% Pd, 2.1 wt.% Co and 2.1 wt.% S (Pd/Co-SZ-2) exhibited remarkable performance under lean conditions and displayed stability in a long-term durability test using a synthetic reaction mixture containing 10% water vapor. This catalyst exhibited the highest sulfur retention most probably as cobalt sulfide. Besides, the catalytic oxidation of NO to NO_y groups was confirmed by FT-IR, in agreement with the general mechanism for the SCR of NO by hydrocarbons. In the absence of oxygen in the feed stream, the catalyst was highly active for NO reduction with methane. IR stretching bands assigned to N₂O and adsorbed nitro groups were identified upon adsorbing NO on Pd/Co-SZ-2. This indicates that under rich conditions disproportionation of NO to N₂O and NO₂ occurs and confirms that the formation of NO₂ species is an essential step for NO reduction by CH₄.     

气相法二氧化硅应用机理及特性

主要介绍了气相法二氧化硅在液态体系、干燥体系、固态体系中的作用机理；气相法二氧化硅在应用中的特殊性能；以及比表面积、pH、含水量、添加量、表面处理程度等气相法二氧化硅各项物理性能对应用性能的影响。     

Miniemulsion and conventional emulsion copolymerization of styrene and butadiene: Effect of process on gel content

The properties of styrene/butadiene copolymers obtained by conventional emulsion and miniemulsion polymerizations were studied. Thin layer chromatography with flame ionization detection was used to determine the gel fraction of the copolymer in the latex particles as a function of conversion. It was found that the gel formation began at a higher conversion in the miniemulsion polymerization when compared with that in the conventional process. Also, a lower glass transition temperature was noted at the lowest conversion sampled (～25%), implying a higher initial butadiene monomer concentration within the nucleated miniemulsion monomer droplets when compared with particles formed conventionally. © 2006 Wiley Periodicals, Inc. J Appl Polym Sci 102: 4616–4622, 2006     

钛掺杂硅胶块体吸附剂

以陶瓷纤维纸片为基材,顺次经水玻璃、酸性钛盐溶液浸渍共沉淀制得新型陶瓷基钛掺杂硅胶块体吸附剂.多孔介质表面分析显示:掺杂硅胶孔径在0.5～6 nm范围,以中孔为主.Fourier变换红外谱在波数954 cm 1处的特征吸收峰表明吸附剂中形成了Si-O-Ti键.根据掺杂前后固体魔角核磁共振硅谱中硅原子化学位移的变化(向高场方向移动)及X射线光电子能谱中各原子结合能的变化(Ti2p3/2的结合能随钛含量的增加而增加,而Si2p,O1s的结合能则呈相反趋势)进一步表明:钛原子替代硅原子进入硅胶网络.热重分析及烧结实验结果显示:钛掺杂吸附剂具有更好的热稳定性.新型吸附剂优异的吸附性能除了与其高的比表面积相关外,还与Ti-O键对水分子的亲合力紧密相关,其耐热性能增强与形成高热稳定性Ti-O Si键及材料表面导热性能提高有关.     

Synthesis and property of nanosized palladium catalysts protected by chitosan/silica

A chitosan (CTN)/silica‐supported nanosized palladium catalyst was obtained from a silica‐supported chitosan palladium complex through a complex transition method. An adsorption model was employed to simplify the structure of the di‐supporter. It was indicated that when the polymer coil adsorbed on the silica surface with even a monolayer the catalytic activity would reach an optimum value, and different situations of the, nanosized palladium particles would cause a different catalysis. The molar ratio of the chitosan structure unit to the palladium would affect the metal's size, which therefore influenced its catalytic activity. The experimental results corresponded with the inferences. © 2002 Wiley Periodicals, Inc. J Appl Polym Sci 85: 989–994, 2002